INSTALLATION INSTRUCTIONS FOR PART 95-8210
APPLICATIONS
Toyota 4-Runner Limited
2003-2009
95-8210
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
KIT COMPONENTS
A) Double Din Trim Plate • B) Double DIN Brackets
B
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-1761 - Toyota harness 1987-up
• TYTO-01 - Toyota amp harness 2003-UP
Antenna Adapter:
A
• Not required
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Socket Set
1-800-221-0932
© COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
95-8210 DASH DISASSEMBLY
Toyota 4-Runner Limited 2003-2009
A
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
2
3
Unsnap and remove trim from around
shifter. (Figure A)
Unsnap and remove center console
cover. (Figure B)
B
4
5
Unsnap trim ring from around ignition
key cylinder.
Remove (1) 10 mm bolt from bottom
right side of panel below steering col-
umn. Unsnap panel and pull away to
gain access behind panel. (Figure C)
C
6
Remove (1) 10 mm bolt on bottom left
of center panel behind panel below
steering column. ( (Figure D)
D
1
95-8210 DASH DISASSEMBLY
Toyota 4-Runner Limited 2003-2009
E
Remove (1) 10 mm bolt beneath cli-
mate control behind pocket door.
(Figure E) Unsnap climate control,
unplug and remove climate control.
(Figure F)
7
8
9
Remove (2) 10 mm bolts beneath
radio behind climate controls.
(Figure G)
F
Unsnap and remove entire center
panel around radio.
10 Remove (2) 10 mm bolts securing
radio. Unplug and remove radio.
(Figure H)
Continue to final assembly.
G
H
2
95-8210 KIT ASSEMBLY
DOUBLE DIN RADIO PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
Snap the factory brackets to the side
of the radio. (Figure A)
1
2
Snap the Double DIN brackets to the
outside edge of the Double DIN trim
plate. (Figure B)
3
Slide the Double DIN radio into the
bracket/trim plate assembly and
secure the radio to the assembly
using the screws supplied with the
radio. (Figure C)
B
Continue to final assembly.
C
3
95-8210 KIT ASSEMBLY
STACKED ISO UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
Snap the factory brackets to the side
of the radio. (Figure A)
1
2
Snap the Double DIN brackets to the
outside edge of the Double DIN trim
plate. (Figure B)
3
Slide the stacked ISO mount units into
the bracket/trim plate assembly and
secure the units to the assembly
using the screws supplied with the
units. (Figure C)
B
Continue to final assembly.
C
4
95-8210 FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5
95-8210 INSTRUCTIONS
1-800-221-0932
REV. 06/03/09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION INST95-8210
|