Analog/Digital String Instruments
OWNER'S MANUAL
PERFORMER CROSS-OVER BASS
MODEL PB-304
TABLE OF CONTENTS
INTRODUCTION ..........................................................................................................................................................1
PERFORMANCE APPLICATIONS...........................................................................................................................2
CONTROL FUNCTIONS.............................................................................................................................................2
PICKUP SYSTEM AND PREAMP .............................................................................................................................2
INTERNAL MIXING BOARD.....................................................................................................................................2
TELESCOPING ENDPIN AND UPPER BOUT GUIDE...........................................................................................3
TRIPOD MOUNTING SYSTEM .................................................................................................................................3
LIGHTWEIGHT TUNERS ............................................................................................................................................3
STRINGS ........................................................................................................................................................................3
INSTRUMENT CARE...................................................................................................................................................3
BRIDGE ADJUSTMENTS ...........................................................................................................................................3
DOUBLE ADJUSTING TRUSS ROD........................................................................................................................4
BATTERY.......................................................................................................................................................................4
TROUBLESHOOTING.................................................................................................................................................4
LIMITED WARRANTY................................................................................................................................................5
SPECIFICATIONS ........................................................................................................................................................5
INTRODUCTION
Congratulations on your purchase of the ZETA Performer Cross-Over Bass. Zeta’s Cross-Over
Basses are designed to give the bass player the ability to successfully produce the sound of an
acoustic bass - whether playing in a strapped-on bass guitar position, or when played in an upright
Owner's Manual
3
Internal trim pots for volume can be adjusted using a small standard screwdriver. Clockwise
rotation decreases volume; counter-clockwise rotation increases volume. To ensure an even
volume balance, it is recommended that you have the instrument plugged into an amplifier while
adjusting the trim pots, and check each string's volume by plucking the string after making
adjustments.
If you are not comfortable making internal volume adjustments, please refer servicing to a qualified
technician or your local Authorized Zeta Dealer.
TELESCOPING ENDPIN AND UPPER BOUT GUIDE
These accessories convert the Cross-Over so that it can be played in an upright position. Simply
insert the telescoping endpin into the base of the instrument and turn it clockwise until the screw
threads engage and hold it in position. The upper bout guide is screwed in place with the two
thumb screws onto the upper back of the instrument, and features thumb screws for adjusting the
playing angle of the Cross-Over. The upper bout guide is designed to simulate the contours of an
acoustic upright bass, and provides support of the bass by leaning against the player's midsection.
TRIPOD MOUNTING SYSTEM
The optional ZOS-5 Tripod Stand mounts in the lower body cavity, in place of the Telescoping
Endpin. While the instrument is mounted on the ZOS-5 Tripod Stand, please be certain that the
tripod feet are fully expanded as the instrument could be accidentally knocked over.
LIGHTWEIGHT TUNERS
Gotoh lightweight tuning machines are designed to hold the strings at pitch for long periods of
time without needing readjustment. Gotoh lightweight tuning machines have a 20:1 tuning ratio.
STRINGS
Please note: For optimum instrument performance, strings should be changed at least once every
month.
Factory Supplied Strings:
ZETA XBS-4 or XBS-5 CrossOver Bass Strings, High Finish Ribbon Wound, Soft Gauge, Long
Scale (34"):
G: 1.14mm/.045 inch
E: 2.54mm/.100 inch
D: 1.65mm/.065 inch
A: 2.03mm/.080 inch
ZETA strings are available at your Authorized ZETA Dealer. ZETA strings are manufactured in
collaboration with the D'Addario String Company.
INSTRUMENT CARE
CLEANING. Do not clean your instrument with chemical solvents such as benzene or alcohol.
Wipe only with a clean dry cloth or use a high quality non-abrasive instrument polish.
SET UP. ZETA recommends that you have your neck adjusted seasonally by a qualified instrument
repair person or luthier, or at your local Authorized ZETA Dealer.
BRIDGE ADJUSTMENTS
Zeta Music
4
Owner's Manual
There are two thumb screws beneath the bridge. The bridge may be raised or lowered on both sides
to accommodate your playing style. It is recommended that the strings be slightly loosened before
making any adjustments. Do not use pliers on the thumbscrews as the instrument's finish and
screws may be damaged. Also, intonation may be adjusted by changing the angle at which the
bridge meets the strings.
DOUBLE ADJUSTING TRUSS ROD
The truss rod is located where the neck meets the body. Turning the truss rod clockwise adds
tension and up-bow to your neck; turning the truss rod counter-clockwise relieves tension and
adds down-bow to your neck. We recommend that you have your neck adjusted seasonally by a
qualified instrument repair person or luthier, or at your local Authorized ZETA Dealer.
BATTERY
This instrument contains quiet pre-amplified electronics within the compartment on the back of the
instrument. Two 9-volt batteries power the circuitry and should be changed after 1,000 hours of
playing use. Plugging in the ¼" cable activates the preamp. When the instrument is not in use
(overnight), unplug the amplifier cord from the ¼" jack so that the battery is not being discharged.
TROUBLESHOOTING
Don’t Panic!
No Output
1. Try increasing volume.
2. Try using a different ¼" cable.
3. Try replacing the internal 9-volt batteries with fresh ones.
String(s) Dead or Low Level Output
1. Check to see if the string is sitting properly on the bridge.
2. Check to ensure that the steel ball at the end of the string is in good contact with the tailpiece.
If necessary, scrape away any thread winding on the string that may be preventing a clean
metal-to-metal contact.
3. Try replacing the internal 9-volt batteries with a fresh ones.
4. Try raising the internal volume of the affected string(s).
Hum, Hiss or Distortion
1. Try using a different ¼" cable.
2. Your amplifier may not be properly grounded. If your amplifier has a "ground reverse" or
"ground lift" switch, try changing it's position.
RETURNING UNITS FOR SERVICE
If your unit requires service, please follow these steps:
1. Contact your authorized Zeta Dealer for a Return Authorization (RA) number.
2. Pack the unit in its original carton with packing materials.
3. Please include a note with the following information:
a. A brief explanation of the problem you are experiencing.
b. Your full contact information: Full name, street address, city, state, zip, country (if not
USA), phone number(s), and email address.
c. Copy of your original purchase receipt.
3. Write the RA number on the outside of the shipping container. Shipments sent to ZETA without
an RA number are refused.
Zeta Music
Owner's Manual
5
4. Ship via UPS, Federal Express, or US. Postal Service. You will be responsible to pay the freight
to and from the ZETA factory. (We also recommend that you insure the unit.)
5. If the unit is under warranty, ZETA will perform the servicing at no charge. Be sure to send a
copy of your original purchase invoice for proof of warranty coverage.
6. If the unit is not under warranty, ZETA will bill you for the servicing and return shipping
charges. We require payment in advance or cash on delivery (COD) for these charges.
LIMITED WARRANTY
All ZETA products carry a 2-year Limited Warranty for parts and labor. ZETA electronics such as the
pickup system and preamp carry a 2-year Limited Warranty. ZETA will replace defective parts and
make necessary repairs at no charge if factory inspection reveals faulty workmanship or material.
This warranty does not cover strings, tuners, batteries, and finishes. This warranty does not cover
damage due to misuse, accident or neglect.
ZETA retains the exclusive right to make such
determination on the basis of factory inspection. ZETA shall not be liable, under any circumstances,
for damage based upon inconvenience, loss of use of the unit, loss of time, interrupted operation or
commercial loss, or any other damages, whether incidental, consequential or otherwise, except
damages which may not be excluded under applicable law.
Products returned to the factory must first receive authorization from ZETA and must be
shipped prepaid. The Return Authorization (RA) number must be printed on the outside of the
container or shipment will not be accepted by ZETA. The RA number will be valid for 30 days. This
warranty remains valid only if repairs are performed by ZETA, and provided that the serial number on
the unit has not been defaced or removed.
This warranty is expressly in lieu of all other warranties either expressed or implied.
SPECIFICATIONS
GENERAL
Case:
Weight:
Padded gig bag
7 lbs, 12 oz
34"
String length:
BODY
Material:
Swamp Ash, or Maple top with Alder back
Finish:
Oil or high gloss urethane
Std. colors:
Body width:
Body length:
Body depth:
Natural Oil, Black, HoneyBurst, TransAmber
11 1/2"
23 3/4"
1 5/8"
NECK
Type:
2-piece Hardrock Maple, bolt-on
Finish:
Satin
Shape:
Oval
Fingerboard:
Nut:
Shedua
Ebony
Truss Rod:
Double flex, adjustable at body
Neck width at nut:
Neck width at end of neck:
String spacing at bridge:
1 1/2"
2 9/16"
1/2"
ELECTRONICS
Type:
Active
Battery:
Two 9-volt
Controls:
Volume, bass and treble boost (+12dB)
Mid-range semi-parametric EQ with frequency sweep
Piezo-electric elements in StradosÔ bridge
Pickups:
Zeta Music
6
Owner's Manual
Battery compartment:
Shielding:
Batteries mounted inside control cavity
Conductive paint in cavity and on cover
HARDWARE
Bridge:
Zeta composite
Tailpiece:
Tuners:
Machined aluminum
Gotoh, enclosed
CUSTOM OPTIONS:
ACCESSORIES:
Left-handed; custom colors and woods
Omni Swivel Tripod Stand; cello bow
ZETA MUSIC SYSTEMS, INC.
2230 Livingston Street • Oakland, California 94606
510.261.1702 • Fax: 510.261.1708
© 2000 ZETA Music
Not used
Not used
EString Gain
A String Gain
D String Gain
G String Gain
"OVERALL GAIN"
[View of Internal Mixing Board inside of the Crossover Bass. Orientation: bass neck pointing up]
Zeta Music
|