Viking Memory
I N S T A L L A T I O N G U I D E
TOSHIBA®
4. Locate the memory expansion
slot at the top of the open com-
partment. Notice the location of
the slots off-center key.
Portégé 650CT
5. To install a memory module, insert the module into the expansion slot
at an angle and then push it down until it clicks into place. To be certain
that the module is installed correctly, ensure that the off-center notch on
the module is aligned with the off-center key of the expansion slot. The
module can only be installed one way due to the position of the notch.
Manual No. 1005147 • Release 02/99, Rev. G
®
S P E E D
P O W E R
P E R F O R M A N C E
The Toshiba Portégé 650CT comes standard with 16MB of memory sol-
dered. It can be expanded to a maximum of 80MB by installing the fol-
lowing Viking Components memory options into its one available expan-
sion slot.
6. Replace the memory expansion cover and be sure to secure its holding
screw.
Description
Viking P/N
16MB EDO Memory Module
32MB EDO Memory Module
64MB EDO Memory Module
T2039, RT2039
T2043, RT2043
T2044, RT2044
7. Replace the battery back into its compartment. Then replace its cover.
8. Turn the computer right-side up. Replace the AC power supply and
any other cables you may have disconnected.
9. Open the display screen and turn the system on. The computer will
automatically reconfigure itself to recognize the newly added memory.
The new memory can be verified during the POST routine at start-up and
at the SETUP utility.
Caution:
Electro Static Discharge (ESD) can damage electronic components. Before
touching the memory module, ensure that you are discharged of static elec-
tricity by touching a grounded metal object.
The installation is now complete.
INSTALLATION INSTRUCTIONS:
WARRANTY & DISCLAIMERS:
1. Turn the computer off and disconnect the AC power supply and any
other cables from the unit.
All Viking Components products have been thoroughly tested free of defects in material and
workmanship. If any malfunction should occur while using one of our products in its recom-
mended environment, Viking, at its option, will repair or replace the product at no charge, pro-
vided the product or any part thereof has not been abused, misused, neglected, replaced,
Note: If the unit appears to be powered down, ensure that it is not in
Suspend mode.
2. Turn the computer upside-down. Remove the battery from the system. repaired or modified. Viking shall make the final determination as to the existence and the
cause of any defect. Viking will not repair or replace products designated as having a “Limited
Lifetime” which fail solely because their estimated life has expired. No warranty is made with
respect to customer products produced to original purchaser specifications except as specifi-
If you are not familiar with this procedure, please refer to your comput-
er’s “Owner’s Manual.”
cally stated in writing by Viking.
3. Locate the memory expansion cover towards the center-right edge of
All shipping costs shall be the responsibility of the purchaser.
the bottom panel. Also locate its holding screw on the cover. Use a small
Except as provided herein, there are no express or implied warranties of merchantability or fit-
ness for a particular purpose. Under no circumstances will Viking Components be liable in
any way to the purchaser for any damages, including but not limited to lost revenue, lost
wages, or any other incidental or consequential damages arising out of the use of or inability
to use this product. Viking reserves the right to make modifications in both hardware and soft-
ware without prior notifications.
Phillips screwdriver to remove the holding screw. Then remove the cover
by lifting it up.
All Viking Components are 100% guaranteed compatible with the OEM machines for which
they are designed. All OEM's names, trademarks and part numbers are used for identification
purposes only, and in no way imply that any of our products are original equipment parts.
Toshiba and Portégé are a registered trademarks of Toshiba America Information Systems.
Product names mentioned herein may be trademarks or registered trademarks of their respec-
tive companies.
Copyright 1999 Viking Components, Inc.
|