EZ•Swap Quick Installation Guide
Model MRK-103F
1. Front Panel Description
6
1. HDD Access indicator
5
2. Power indicator
3. Active-handle
4. Handle
5. Cartridge frame
6. Key lock
4
1
2
3
2. Function Settings and Operation
2-1 Power Indicator and HDD Access indicator
When power is turned on, the indicator will displays the following
Item
Power Indicator
HDD Access Indicator
Indicator
Green LED
Amber LED
2-2 Key lock
Status
Segment
Power status
Security status
A
B
A
B
C
ON
OFF
OFF
Locked (Irremovable)
Locked (Irremovable)
Unlocked (Removable)
C
3. Installing Hard Drive into Cartridge
Step 1
1-1. Pull the active-handle outwards and use the miniature key provided and insert into the key hole,
turning the key anti-clockwise, then the handle will auto-eject for pulling out. (Fig.1)
Fig. 1
Copyright 2002 Vantec Thermal Technologies, INC.
All Rights Reserved
Model MRK-103F
Step 5
5-1. Slide the carrier body back into the cartridge frame. (Fig.7)
Fig. 7
5-2. Push carrier body further into cartridge frame until fully inserted. (Fig. 8)
Fig. 8
Step 6
6-1. Install the module into a 5.25” half-height expansion bay. Insert the DC power cable and the IDE
cable of the user’s chassis to connectors located at the back plane of the cartridge frame. Then,
fully secure the module to the chassis by using the four M3x6 screws provided. (Fig.9)
Fig. 9
6-2. Pull the active-handle outwards and use the miniature key provided and insert into the key hole,
turning the key clockwise to secure the handle. (Refer to section 2-2 Key lock)
Copyright 2002 Vantec Thermal Technologies, INC.
All Rights Reserved
|