Issue 0
V-2960A
NTSC Color Video Camera
Introduction
The V-2960A is a NTSC Format, Color Video
Camera designed for use with the Valcom Class
Connection Baseband Video System. The
V-2960A is wall mountable or may be mounted
on a single gang electrical box.
FCC Information
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
Environment:
environment. This equipment generates, uses
and can radiate radio frequency energy and if not
installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area may cause
harmful interference requiring the user to incur
expense to correct the interference.
Temperature:
Humidity:
0 to + 40°C
0 to 80% non-precipitating
For indoor use only.
Installation
All necessary connections are made via the
RJ-45 connector on the camera. Cable pin outs
from the top of the plug:
Specifications
Features
W/O
O/W
W/G
BL/W +24VDC
W/BL +24VDC
G/W
W/B
B/W
N/C
N/C
Ground
Manually adjustable focus, pan and tilt
Output matched for use with twisted pair
cable
Centrally powered from headend equipment;
No remote power supply required
Ground
Video +
Video –
Connections made via an RJ-45 jack
Dimensions/Weight
Camera mounted in bell box with faceplate:
4.63" H x 2.80" W x 2.00" D
(11.76cm H x 7.11cm W x 5.08cm D)
1 lb. (.45 kg.)
Mounting
Install the V-2960A per figure 1. Bend the
mounting bracket to adjust pan and tilt as
required. Insert a small screwdriver into the slots
on the lens assembly of the camera and turn the
lens to adjust the focus if necessary. The
V-2960A enclosure features top and bottom
knockouts to accommodate cable routing.
Nominal Specifications
Power requirements:
Output Impedance:
Video format:
24VDC, 40mA
100 Ohms
NTSC
Focal length:
4.6mm
Max Aperture:
f2.8
1
947983
|