Ultra Start Automobile Alarm KEU 300 User Manual

OWNERS GUIDE  
Covers All KEU-300 Series Advanced Factory  
Keyless Upgrade Security Systems  
Technical Support: 866-698-5872 ext 0  
FCC/ID Notice  
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:  
(1) This device may not cause harmful interference, and  
(2) This device must accept any interference received, including interference that may cause  
undesired operation.  
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance  
void the user’s authority to operate this devise.  
 
REMOTE VEHICLE STARTER  
OWNER’S GUIDE  
Page 3  
System Operation  
Passive Arming (optional)  
Turn the ignition to the “OFF” position and exit the vehicle.  
Upon closing the last door the LED will begin flashing  
rapidly to confirm the system is passively arming. After 30  
seconds the siren will chirp and the parking lights will flash  
once to confirm the system has passively armed.  
NOTE: If installed the optional starter kill feature will be  
activated and if the optional locks are installed the  
system will lock the doors.  
Panic  
1. Press and release the LOCK button on the remote  
transmitter four times within five seconds. The system will  
begin to flash the parking lights and the siren will sound.  
2. To disable press and release the UNLOCK button on the  
remote transmitter.  
2nd Channel Output (optional auxiliary output)  
Press and release the LOCK button on the remote  
transmitter two times within three seconds. The system will  
activate an auxiliary output.  
NOTE: This feature may be used to activate a remote  
starter or activate a power trunk release.  
Domelight Supervision (optional feature)  
Upon disarming the system will activate the interior lights for  
30 seconds to illuminate the interior of the vehicle.  
 
OWNER’S GUIDE  
Page 4  
REMOTE VEHICLE STARTER  
System Operation  
Service Mode/ Emergency Override  
To enter:  
1. Turn the ignition to the “ON” position.  
2. Press and hold the Program Button for 5 seconds. The  
system will respond with 5 siren chirps and the LED will  
turn “ON” solid.  
Ignition  
“On”  
To exit:  
1. Turn the key to the “ON” Position.  
2. Press and hold the Program Button for 5 seconds. The  
system will respond with 2 siren chirps and the LED will  
be “OFF”  
Car Jack Mode (optional feature)  
To Enable:  
Car Jack Mode is activated by opening the door while the ignition  
key is in the “ON” position. The LED will begin to blink rapidly for 30  
seconds, then the system will chirp the siren for 10 seconds.  
To Disable:  
1. Within the 40 second period, Car Jack Mode can be disabled by  
pressing and releasing the program switch.  
2. After the 40 second period the system will be in full trigger and  
can only be disabled by turning the ignition to the “ON” position  
and press and release the program button 5 times.  
LED Status  
LED  
ON  
OFF  
Slow Flash  
Rapid Flash  
2 Flashes  
4 Flashes  
Status  
Service Mode or Open Door  
System Disarmed  
System Armed  
System Passive Arming or Car Jack Mode Active  
System has been Triggered by Shock Sensor  
System has been Triggered by Door Input  
 

Teac Computer Drive CD W28PU User Manual
Thermador Food Warmer WD27 User Manual
Thomas Betts Furnace RGM 405 User Manual
Toro Lawn Mower 14AP80RP544 User Manual
TP Link Network Router M5350 User Manual
Transcend Information MP3 Player TS4G User Manual
Ultra Products Network Card ULT40127 User Manual
Victory Refrigeration Food Warmer HS 1D 7 EW User Manual
ViewSonic Flat Panel Television VPW5500 User Manual
VocoPro Stereo System DIGITAL KARAOKE SYSTEM User Manual