OWNERS GUIDE
This Manual Covers All 1250 Series
Remote Vehicle Starters
U.S.A. Model
REMOTE STARTERS
CAR ALARMS
ü
WWW.ULTRASTARTERS.COM
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the user’s
authority to operate this devise.
-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
Owners Guide
REMOTE STARTER FEATURES
Remote Start
1.Press and release the
button.
2.The Park lights will flash and the horn(optional) will honk one time.
3.When the vehicle has started, the system will flash the park lights four times then remain “On” while
the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
Extended Run Time
1.Press and release the button while the vehicle is remote started.
2.The system will respond with one park light flash and one horn honk (optional) to
confirm Extended Runtime. The system will reset the run time, (normally 15 minutes).
Remote Stop
1.Press and hold the button for three seconds. The remote starter will shut down.
2.The park lights will flash two times and the horn(optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
3 sec.
Idle Mode
1.While the vehicle is running with key, press the
button.
2.The park lights will turn on and the horn(optional) will honk once.
3.Turn the ignition key “Off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Always lock the doors if the
vehicle is left running.
While
running
Timer Mode. (Starts the vehicle in at a pre-set start interval)
1.Press and release the # button, then press and hold the
turn “On” to confirm entering Timer Mode.
2. Whilethe parklightsare“On”thestartcycle canbeselected.
button for six seconds. The parking lights
1 hour cycle
2 hour cycle
3 hour cycle
4 hour cycle
Press LOCK
button
Press UNLOCK button
1 Park Light Flash
2 Park Light Flashes
3 Park Light Flashes
4 Park Light Flashes
1st
2nd-6 sec
Press
Press
button
button
#
3. The system will start the vehicle at the selected start cycle. The vehicle will run for it’s runtime then
shut off. The system will repeat this for a maximum 24 hour period.
TO CANCEL TIMER MODE
1. Press and release the # button, then press and hold the
button for four seconds.
2. The System will respond with two flashes and two horn honks (optional).
3. Starting the vehicle with the key or by remote will also disable Timer Mode.
Diagnostics
PARK LIGHTS
3 Flashes
3 Slow Flashes
4 Slow Flashes
5 Flashes
5 Slow Flashes
6 Flashes
7 Flashes
STATUS LED
Series of 3 Flashes
LED’s On Solid
Series of 4 Flashes
Series of 5 Flashes
Series of 5 Flashes
Series of 6 Flashes
Series of 7 Flashes
Series of 8 Flashes
DIAGNOSTIC CODE
Door Opened “M” Models
System Is In Service Mode
Not in Reservation Mode “M” units
Brake Pedal Shutdown
Ignition On During Start Attempt
Hood Pin Grounded
Tach Lock-Out
8 Flashes
3 Start Attempts with no start
ATTENTION: THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER HOOD
SERVICING IS DONE TO THE VEHICLE. IT IS THE RESPONSIBILITY OF THE VEHICLE’S OWNER TO
INSURE THAT THIS IS DONE. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR
ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.
Remote Service Mode (Valet Mode)
Service Mode disables the remote starter from operating. It will be necessary to activate
Service Mode when having the vehicle serviced.
ENTERING SERVICE MODE
1.Press and release the # button, then within two seconds press and hold the same # button
for five seconds or until the horn(optional) honks five times. The LED’s on the antenna will
come “On” and then stay on solid to confirm that the system is in Service Mode.
1st - ½ sec
2nd - 5 sec
EXITING SERVICE MODE
1.Press and release the # button, then within two seconds press and hold the same # button
for five seconds or until horn(optional) honks two times.
Note: If the remote start button is pressed when the system is in Service Mode the park
lights will flash 3 times. Remote start and Alarm functions will be disabled and the
LED‘s will be “On”Solid. The door locks and the trunk release will still be operational.
Emergency Service Mode (Valet Mode)
This feature will disable the system except for locking and unlock functions.
This mode can also used if a remote is lost, damaged or if the system malfunctions.
ENTERING SERVICE MODE
1.While the ignition is “On” press and hold the Program Button for 5 seconds or until the horn (optional)
honks five times.
EXITING SERVICE MODE
Ignition
“On”
1.While the ignition is “On” press and hold the Program Button for 5 seconds or until the horn (optional)
honks two times.
5 sec.
Note: Remote starter functions will be disabled and the LED will be “On” steady.
The door locks and the trunk release will still be operational.
WARRANTY
The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects
in material and workmanship. However, should this product be proven to be defective, within a two year period from the original
date of purchase, the manufacturer will, without charge to the purchaser (excluding any charges incurred to have the product
delivered to the manufacturer) , repair or replace any part of the remote starter and/or alarm which the manufacturer agrees to be
defective. All warranties apply on to the original purchaser and the vehicle in which it is originally installed. Repairs or replacement
of defective modules shall remain at the discretion of the manufacturer. All other parts, components, accessories and/or optional
equipment pertaining to the remote starter and alarm are not included in the manufacturer’s warranty. This warranty is non-
transferable. Request for warranty service from any Factory Authorized Dealer must be accompanied with the original
purchase receipt or have product registered by authorized dealer on manufacturer’s website. Failure to comply with any of
these conditions may result in warranty being voided.
This warranty does not cover the following: removal and reinstall labour charges, shipping charges, abuse, misuse, or accidental
damages to the remote starter and alarm, automobile, and/or parts there of. This warranty is void upon modification, repairs, or
alterations of any part of the System. The manufacturer does not guarantee or insure against theft of the vehicle or its contents.
Alarm models are designed only to act as a deterrent against possible theft. This alarm may qualify for auto insurance discounts,
contact your Insurance Agent for further information . The manufacturer shall not be held liable for any consequential damages due
to breach of this or any other warranty, expressed, or implied. This warranty gives you specific legal rights. Your specific legal
rights may vary for each region.
CERTAIN DAMAGES EXCLUDED - The manufacturer expressly disclaims any liability or responsibility for incidental damages
caused by the product, including economic loss, loss of use of the product, car rentals, or any other costs relating to the care and
custody of the product. The manufacturer disclaims liability or responsibility for any consequential damages caused by the product
or resulting from its use, including the cost of repairing or replacing other property damaged by the product or caused by its use,
whether or not the product is working properly. The product is intended to deter unauthorized use of the vehicles in which it is
installed. The manufacturer does not warrant that the product is fool-safe against theft and/or vandalism and/or human error or
misuse. The manufacturer accepts no liability or responsibility for any damage of any kind whatsoever caused to any vehicle in
which the product is installed or any resulting damage from its use. The manufacturer accepts no responsibility or liability for any
damage resulting to or theft of the vehicle or its contents, caused or alleged to be caused, directly or indirectly, by failure of the
product.
|