Toro Sprinkler 720G User Manual

720G ADJUSTMENT INSTRUCTIONS  
TM  
The 720G part circle model is factory preset to 3 GPM, 180° arc and 25° trajectory. The full circle model is preset to 6 GPM, 360° arc and  
25° trajectory. To adjust these settings, use the following procedures.  
Adjust Flow  
Flow is adjustable from 1 to 9 GPM  
Adjust Arc (part circle models only)  
1
2
2
2
Arc is adjustable from 40° to 360°  
1
+
S
+
U
Part Circle - Factory preset to 3 GPM  
• Factory preset to 180°  
I
D
Full Circle - Factory preset to 6 GPM  
• Only right side of arc  
is adjustable  
O
l
1
Tip Flow adjustment can be made  
+
wet or dry.  
Tip Arc can be adjusted wet  
or dry. Turn nozzle to left stop  
before changing arc.  
9
34  
F
+
S
8
U
I
30  
A
R
6
L
23  
+
C
J
4
1
O
R
A
l / m n  
G P M  
D
W
1
1
6
2
1
2
A
7
1
J
1. Insert edge of Toro tool (provided)  
into slot of flow adjust ring.  
4
8
5
1
1
2
1
D
4
3
A
6
1
2
2
30  
23  
8
6
J
8
1. Insert Toro tool into small slot in nozzle top.  
D
A
1
7 l/mn  
1
31  
2. While holding top of nozzle with  
thumb, turn flow adjust ring in either  
direction to align arrow with desired  
flow rate number.  
GPM  
1 42  
5
1
4
2. To increase arc, turn tool clockwise.  
To decrease arc, turn tool counterclockwise.  
Tip Full turn changes arc 180°; half turn changes arc 90°.  
Adjust Radius/Trajectory  
Trajectory is adjustable from 7° to 25°  
Install Sprinkler and Check Arc Setting  
1. Install and tighten sprinkler onto a 34" threaded fitting  
3
4
Factory preset to 25°  
aligning arrow on cover with left watering border.  
1. Insert Toro tool through radius adjust-  
ment hole in top of nozzle cover.  
2. To check arc setting during operation, turn nozzle in  
direction of rotation, releasing just before end of  
arc – observe reversing point. To quickly  
change direction of rotation, turn nozzle  
slightly beyond the arc border to actuate  
the reversing mechanism.  
11  
3
2. To decrease (), turn tool clockwise  
-
A
R
(7° minimum).  
+
C
To increase (+), turn tool counterclock-  
wise (25° maximum).  
3. Fine tune arc setting by turning arc  
adjustment slot right to increase or left  
to decrease.  
Tip 7° setting is not recommended for  
newly seeded areas.  
 

Targus Mouse Wireless Optical Rechargeable Full size Notebook Mouse User Manual
Technicolor Thomson Universal Remote 14MS15UT User Manual
Technika Clock Radio CR121IDAB User Manual
Toshiba DVD Player M750 User Manual
Traulsen Refrigerator RDT132DUT HHS User Manual
Trimline Waterskis t523 User Manual
Ultra electronic Printer Tempo User Manual
Vermont Casting Ventilation Hood DVA4136 User Manual
ViewSonic Projector PJ258D User Manual
Viper Automobile Electronics G4203V User Manual