USER
MANUAL
MODEL 532S
Ethernet 10Base-T (STP)
Surge Protector
Part# 07M532S
Doc# 074171U-A
Revised 11/26/96
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
C
E
R
T
I
F
I
E
D
An ISO-9001
Certified Company
3.0 INSTALLATION
APPENDIX A
Patton's Model 532S units are easy to install and should give you
years of trouble-free service. Here are a few simple instructions to help
you get things hooked up right.
532S SPECIFICATIONS
Protocol/Application: IEEE 802.5 Token Ring, shielded or
1. Unplug (disconnect) the existing connection between the network
cable and the equipment’s I/O port.
unshielded twisted pair
Circuit:
Bipolar, Solid State, 4-wire bi-directional
protection on RJ-45 connectors
2. Install the Model 532S between the incoming network cable and
the protected equipment using the 6” (15.24cm) modular patch
cable (supplied). Place the surge protector as close as possible to
the device being protected.
Maximum Signal Rate: 10 Mbps
3. Connect the braided ground strap directly to a chassis ground
connection on the protected device. If you are unsure where to
locate a chassis ground connection on your equipment, consult the
equipment's user manual or contact the manufacturer—the ground
connection is critical for proper operation of the Model 532S.
RJ-45 Pins Protected: 3, 4, 5 and 6
Response Time:
Capacitance:
Clamps to 7.5V in 0.5µ Sec
18 pF
Output to Protected
Equipment
Input from
Network
Surge Current:
Energy Handling:
Grounding:
400A (8 x 20 S.C. Waveform)
1.5 KW for 1 msec
External connection provides separate unit-
ground to chassis-ground contact
Connection to
Frame Ground
Size:
3.05” x 1.68” x 0.81” (7.74cm x 4.26cm x
2.06cm)
Figure 1. How to Connect the Patton Model 532S
Copyright ©
Patton Electronics Company
All Rights Reserved
3
4
Dear Valued Customer,
Thank you for purchasing Patton Electronics products! We do
appreciate your business. I trust that you find this user manual helpful.
We manufacture one of the widest selections of data communications
products in the world including CSU/DSU's, network termination units,
powered and self-powered short range modems, fiber optic modems, interface
converters, baluns, electronic data switches, data-line surge protectors,
multiplexers, transceivers, hubs, print servers and much more. We produce
these products at our Gaithersburg, MD, USA, facility, and can custom
manufacture products for your unique needs.
We would like to hear from you. Please contact us in any of the
following ways to tell us how you like this product and how we can meet your
product needs today and in the future.
Web:
(301) 975-1000
(301) 975-1007
(301) 869-9293
Sales E-mail:
Support E-mail:
Phone - Sales
Phone - Support
Fax:
Mail:
Patton Electronics Company
7622 Rickenbacker Drive
Gaithersburg, MD 20879 USA
We are committed to a quality product at a quality price. Patton
Electronics is BABT and ISO 9001 certified. We meet and exceed the highest
standards in the industry (CE, UL, etc.).
Please contact us and let us know how we may provide you with the
answers to your needs.
Thank you.
Burton A.Patton
Vice President
P.S. Please tell us where you purchased this product.
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
_________________________________________________________
5
|