Fire alarm systems
Addressable siren
3377
•
•
•
High sound output but low current consumption
Three different tones and priority levels
Connected directly on the COM loop
The siren can, for example, be used for pre-
warning, fire alarm and general fire alarm,
with a different tone for each type of alarm.
General
The siren is a general purpose sounder that
consists of a horn (incl. all electronics) and a
back box, which has double cable entries. It
is made of red ABS plastic. The COM loop
is connected directly to the siren via a plug-
in 4-way terminal block (2 in/2 out).
Address & Mode setting
For COM loop address setting, the address
setting tool 3314 is used. The siren has an
address label where the address is to be
written. 3314 is also used to set the mode:
High sound output
The siren has a high sound output but a low
current consumption. The volume can be
adjusted via a potentiometer.
•
NORMAL mode:
Win512 / Win128).
3377 (3377 in
•
•
2330 mode: Can not be used.
2312 mode: Can not be used.
Tones
Miscellaneous
The address setting tool 3314 is connected
directly to siren's connectors when the
terminal block is unplugged.
Three tones are available:
•
•
Continuous 990 Hz
Pulsed (Intermittent) 990 Hz,
0.5s / 0.5s
The siren is power supplied via the COM
loop, i.e. the number of sirens is depending
on the type and number of other units
connected to the same COM loop.
•
Two-tone (Alternating) 980/645 Hz,
0.25s / 0.25s
Priority levels
Product applications
Used in the systems EBL512 (SW version >
2.2) and EBL128. The siren is intended for
indoor use and in dry premises.
Three priority levels are available in system
EBL512 and two in system EBL128. For
each level an output control expression and a
tone is programmed (via Win512 / Win
128).
Panasonic Electric Works Fire & Security Technology Europe AB
Citadellsvägen 23, SE-211 18 Malmö, Sweden
Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99
|