Panasonic Smoke Alarm 3333 User Manual

Fire alarm systems  
Addressable manual  
call point  
3333  
Attractive design compliant with EN54-11  
Test key for routine testing without breaking the glass element  
Protection against accidental operation  
General  
LED indicator  
An LED on the front cover indicates fire  
alarm generated by the call point.  
Flashing LED: The LED will flash each  
time the c.i.e. communicates with the call  
point, until the call point is operated and the  
LED is switched on.  
Non-flashing LED: The LED is switched  
off, until the call point is operated and the  
LED is switched on.  
The call point has an attractive design  
compliant with EN54-11, and is either  
surface mounted in the supplied red backbox  
or recess mounted in a standard UK single  
gang box or a Swedish 65 mm circular  
backbox. It has a clip retained front cover  
that makes it easy to replace the glass  
element and adds security since the clips are  
concealed. The frangible element is a glass  
element with a protective plastic film. To  
operate the call point, the glass element is  
pressed until it is broken. This will activate  
the built-in microswitch, which will generate  
a fire alarm in the c.i.e.  
Connections / Settings  
The COM loop is connected directly to the  
call point via a 4-way terminal block. For  
COM loop address setting is the address  
setting tool 3314 is used. 3314 is also used  
to set the call point type and the LED mode:  
Test key  
Routine testing is made with a supplied test  
key, without breaking the glass element.  
Inserting the test key simulates the breaking  
of the glass element. The call point is  
automatically reset when the test key is  
removed. The test key is also used to  
release the security clips for the front cover.  
NORMAL mode (EBL512 SW version  
> 2.0 / EBL128): M.c.p. type 3333.  
(Flashing or non-flashing LED is set via  
Win512 / Win128.)  
2330 mode: M.c.p. type 2333, flashing  
LED.  
2312 mode: M.c.p. type 2333, non-  
flashing LED.  
Protective cover  
Two flying leads (wires) are connected to  
the terminal block, for connection of the  
3314 address setting tool's connection cable.  
The wires are to be disconnected before the  
COM loop wires are connected.  
To protect the call point against accidental  
operation, a transparent polycarbonate cover  
has to be lifted to get access to the glass  
element.  
Encapsulated circuit  
All electronics are encapsulated. Only the  
terminal block is accessible from the rear.  
Product applications  
Used in the systems EBL512 / 128 / 1000 /  
2000 and is intended for indoor use and in  
dry premises.  
Panasonic Electric Works Fire & Security Technology Europe AB  
Jungmansgatan 12, SE-211 19 Malmö, Sweden  
Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99  
 

Miele Ventilation Hood DA409 User Manual
Miele Washer Dryer W 1513 User Manual
Milan Technology Network Router MIL SM24004TG User Manual
National Instruments Network Card NI 8171 Series User Manual
Northern Industrial Tools Burner 109088 User Manual
Omron Respiratory Product ME C28P User Manual
Panasonic Air Conditioner CS E18GKR User Manual
Panasonic Fax Machine KX PW37CL User Manual
Patton electronic Network Hardware 2715 User Manual
Patton electronic Network Router 4630 Series User Manual