DESCRIPTION OF PARTS (FIG. 1)
A. LCD DISPLAY
B. IN/OUT SWITCH
C. VENT HOLES
DIGITAL INDOOR / OUTDOOR
THERMO CLOCK
Model : NAW881EXT
D. WALL MOUNT HOLE
E. °C/°F SWITCH , H-HOUR BUTTON,
M-MINUTE BUTTON
F. STAND
G. BATTERY DOOR
H. OUTDOOR SENSOR PROBE
BATTERY
The Thermometer uses 1 x UM-4 (AAA)
battery (1.5V D.C.)
Follow these steps to install or replace the
battery:
1. Slide the battery door in the direction
of the arrow.
2. Insert the battery as indicated by the
polarity symbols (+ and -) marked inside
the battery compartment.
3. Replace the battery door.
CLOCK
Press H or M to change the Hour or Minute.
Press and hold to enter fast-setting mode.
SELECT INDOOR / OUTDOOR
TEMPERATURE
The IN/OUT switch on the front of the
Themo-Clock selects between indoor /
outdoor temperature. Slide to the IN
position for indoor temperature. Slide to
the OUT position for outdoor temperature.
SELECT MEASUREMENT UNIT
INTRODUCTION
The slide switch on the back of unit selects
between degree Celsius and Fahrenheit.
To select Celsius units, set the slide to °C.
To select Fahrenheit units, set the slide
switch to °F.
•
Thank you for your purchase of this
Digital Thermo-Clock.
•
Your Digital Thermo-Clock is an
example of superior design and
craftsmanship.
RESET UNIT
•
•
In order to optimize its functions, be
sure to read this instruction manual
carefully before use.
If your Thermo-Clock doesn’t operate
property, take out the battery from the unit
for 4 to 5 seconds, then reinstall the
battery.
Keep this manual handy for future
reference.
POSITION THE OUTDOOR SENSOR
PROBE (FIG. 2)
FEATURES
•
•
Digital LCD Thermometer with Clock.
I. SCREW
Temperature/Clock alternate display
function at 3 seconds cycle.
J. WIRE ATTACHMENT
•
•
•
User selectable indoor or outdoor
temperature measurement.
Follow these steps to secure the external
probe.
User selectable °C or °F temperature
units of measure.
1. Drive a screw (not included) into the
wall at the location you choose for the
sensor.
Wall mounting and table standing
feature.
2. Hang the outdoor sensor’s wire
attachment loop onto the screw .
3. Route the outdoor sensor’s cord
(3 meters) through the window.
NAW881EXT lab test R1
1
1/9/04, 4:40 PM
Black
|
Miele Iron B 890 User Manual
Miller Electric Welder S 75S User Manual
Moulinex Toaster Isilys Express User Manual
MTD Log Splitter 249 610 000 User Manual
MTX Audio Speaker System MONITOR10 MONITOR12 MONITOR6C MONITOR6 User Manual
Murphy Switch EVS S User Manual
Nexus 21 Marine Radio NX WIRELESS WIND TRANSDUCER User Manual
Optoma Technology Projector EP 610 H User Manual
Panasonic Network Cables CA LSR01U User Manual
Panasonic Scanner 4520 User Manual