Olympus Automobile Electronics i 10 User Manual

INSTRUCTIONS  
Read this manual carefully before using your  
camera.  
 
NEVER ATTEMPT TO DISASSEMBLE  
THE CAMERA; IT CONTAINS A HIGH-  
VOLTAGE CIRCUIT. IF THE INTERNAL  
PARTS OF THE CAMERA ARE  
EXPOSED DUE TO DROPPING OR  
DAMAGE, REMOVE THE BATTERIES  
IMMEDIATELY TO PREVENT  
FURTHER USAGE.  
IN CASE OF MALFUNCTION,  
CONSULT YOUR NEAREST  
OLYMPUS DEALER OR OLYMPUS  
SERVICE CENTER.  
3
 
Names of parts ..................................  
Cartridge ..........................................  
Loading the battery ..........................  
5
7
8
Loading the cartridge film ................ 10  
Taking pictures ................................. 11  
Flash photography ........................... 12  
Unloading the cartridge film ............. 13  
Setting the print type ........................ 14  
Print area on film .............................. 15  
Care and storage ............................. 16  
Specifications...................................20  
4
 
NAMES OF PARTS  
Shutter release button  
AE light sensor*  
Viewfinder  
Lens*  
Red-eye reduction lamp  
Flash*  
Lens barrier switch  
Cartridge cover release  
*Do not soil as this can cause blurred  
pictures. Wipe clean with a soft cloth.  
5
 
Print type selector switch  
Battery check lamp  
Flash ready lamp  
Viewfinder  
Exposure counter  
Strap eyelet  
Cartridge cover  
Mid-roll rewind button  
Battery compartment cover  
Battery compartment cover release  
Picture frame  
Strap ring tip  
ATTACHING THE STRAP  
The camera strap ring tip can be used  
to press the mid-roll rewind button.  
6
 
CARTRIDGE  
IX240 Cartridge Film  
Visual Exposure Indicator  
Only cartridges with the  
(unexposed) visual exposure  
indicator can be used with this  
camera.  
• When a cartridge with other than the  
visual exposure indicator is  
loaded, the camera will rewind the  
film and set the cartridge to  
(exposed).  
• Take along plenty of film cartridges  
when traveling to foreign countries  
and other areas where cartridge  
purchasing may be difficult.  
Do not forcibly move the visual  
exposure indicator because this may  
damage the cartridge. Using a  
damaged cartridge can result in  
camera trouble.  
7
 
LOADING THE BATTERY  
Use one 3V lithium battery (CR2).  
1. Slide the battery compartment  
cover release ( ) and open the  
cover ( ).  
2. Load the battery and align the  
and  
ends correctly.  
3. Turn the lens barrier switch  
(
) to  
turn on the camera. If the battery  
check lamp starts blinking, replace  
the battery ( ). About 15 rolls of  
film can be used with one new 3V  
lithium battery (when the flash is  
used on half of pictures).  
Notes:  
Dispose of used batteries in the battery  
recycling boxes at stores selling batteries.  
If lithium batteries are not fully discharged,  
protect them against short-circuiting (e.g., by  
taping the contacts) before disposal.  
8
 
Battery Handling  
• Observe the precautionary remarks  
written on the batteries.  
• When the camera is not used for an  
extended period of time, remove the  
battery.  
Keep spare batteries on hand when  
going on a long trip or to a cold area.  
Sweat, oil, and so on can prevent a  
battery's terminals from making  
electrical contact. To avoid this, wipe  
both terminals before loading the  
battery.  
9
 
LOADING THE CARTRIDGE  
FILM  
Use unexposed negative-color 1X240  
cartridge film (ISO 100-400).  
1. Make sure that  
is displayed on  
the camera's exposure counter. Turn  
the cartridge cover release  
open the cartridge cover  
to  
2. Insert a cartridge with the  
(unexposed) visual exposure  
indicator and close the cartridge  
cover . The film will automati-  
cally advance to the first frame and  
"1" will appear in the exposure  
counter  
• If the cartridge film is not loaded  
correctly, the two lamps beside the  
viewfinder will blink. Reload  
unexposed film.  
10  
 
TAKING PICTURES  
1. Turn the lens barrier switch  
turn on the camera.  
to  
2. Press the shutter release button  
halfway to make sure the flash  
ready lamp  
• When the flash ready lamp  
blinking, the flash is being  
lights.  
is  
recharged and the shutter cannot  
be released.  
3. Compose the shot in the viewfinder.  
Press the shutter release button  
to take the picture.  
• Working distance: 1.0 m (3.3 ft)~  
•Always turn off the camera when  
you finish taking pictures.  
.
WARNING: SERIOUS EYE  
DAMAGE MAY RESULT FROM  
LOOKING DIRECTLY AT THE SUN  
THROUGH THE VIEWFINDER.  
11  
 
FLASH PHOTOGRAPHY  
Check the flash ready lamp.  
Blinking:The flash is recharging, and the  
shutter cannot be released.  
Lit:  
The flash is charged. Shooting  
is possible.  
Red-eye reduction lamp  
This lamp helps to reduce the red-eye ef-  
fect with flash pictures. The red-eye reduc-  
tion lamp lights when the shutter release  
button is pressed lightly. Press the shutter  
release button after the red-eye reduction  
lamp has been lit for about 1 second.  
Flash Range  
1.0 ~ 2.3m (3.3 ~ 7.5 ft)  
ISO  
200  
400  
1.0 ~ 3.2m (3.3 ~ 10.4ft)  
12  
 
Using negative color film  
UNLOADING THE  
CARTRIDGE FILM  
1. The film will be rewound automati-  
cally when the end of the roll is  
reached  
, Even when the film is  
rewound, the number in the expo-  
sure counter remains the same.  
2. Wait until the motor stops. Ensure  
that the two lamps beside the view-  
finder are blinking. Open the car-  
tridge cover  
3. Remove the cartridge  
tridge visual exposure indicator will  
be set to (exposed).  
.The car-  
•The camera will not operate until  
the rewound cartridge is removed.  
When the cartridge is removed, the  
exposure counter returns to  
4. To rewind the film before the end of  
the roll, press the mid-roll rewind  
button  
using the camera strap  
ring tip or anything equivalent. The  
cartridge will be set to (exposed).  
13  
 
SETTING THE PRINT TYPE  
Set the print type selector switch to the  
desired type: C, H or P.  
Print type selector switch  
C type viewfinder  
H type viewfinder  
P type viewfinder  
Always keep the print type selector  
switch set correctly. The print type  
setting is optically recorded on the film.  
The number of exposures does not  
change even when the print type is  
changed.  
14  
 
PRINT AREA ON FILM  
PrintType Setting Configuration  
Print type  
C type  
H type  
P type  
Aspect ratio  
Approx. 2:3  
Approx. 9:16  
Approx. 1:3  
C
H
P
15  
 
CARE AND STORAGE  
1. Do not leave the camera in any  
place exposed to excessive heat,  
humidity, or direct sunlight — for  
example, in a car or on the beach.  
2. Do not expose the camera to  
formalin or naphthalene.  
3. If the camera gets wet, wipe it with  
a dry towel. The salt in seawater  
can be especially damaging.  
4. Do not use organic solvents, such  
as alcohol or paint thinner when  
cleaning the camera.  
16  
 
5. Do not leave the camera on or near  
a television, refrigerator, or other  
appliance with a magnetic field.  
6. Do not expose the camera to dust  
or sand as this could cause serious  
damage.  
7. Do not shake or shock the camera.  
Keep the camera in a well-ventilated  
place.  
• Do not expose the camera to  
extreme heat (over 40°C/104°F) or to  
extreme cold (below -5°C/23°F). Low  
temperatures, even within this range,  
may sometimes cause deterioration  
in battery performance, temporarily  
disabling the camera.  
17  
 
When transporting the camera from  
a cold place to a warm place or in  
the event of a sudden temperature  
change, put the camera into a plastic  
bag.This allows the camera's  
temperature to change slowly. Once  
the camera has adjusted to the new  
temperature, you can remove it from  
the bag and use it.  
18  
 
Avoid leaving the camera unused for  
long periods of time. This can cause  
mold to grow on the camera as well  
as other problems. Try to press the  
shutter release button and check the  
operation of the camera before use.  
Some airport X-ray machines can  
damage the film in your camera. Try  
to avoid passing your camera  
through these machines. Give it to  
the security officer for manual  
inspection.  
• This camera is not suitable for  
professional use or for use under  
extreme conditions.  
19  
 
SPECIFICATIONS  
Type: Fixed-focus lens-shutter camera.  
Film format: IX240 cartridge film.  
Image size: 16.7 x 30.2 mm.  
Print type: Selection between C, H and P print  
types.  
Lens: Olympus lens, 24 mm F7, 3 elements in  
3 groups.  
Shutter: Programmed electronic shutter  
(1/200 -1/50 sec).  
Viewfinder:Albadaviewfinder 0.33X  
magnification. Flash ready lamp. Battery  
check lamp.  
Focusing: Fixed-focus. Focus range — 1.0 m  
(3.3 ft)~  
.
Exposure counter: Progressive type.  
Film speed: Automatic setting (ISO 100, 200  
and 400).  
20  
 
Film loading: One-touch insertion, automatic  
loading (automatically advanced to first  
frame when cartridge cover is closed).  
Film advance: Automatic film winding.  
Film rewind: Automatic rewind at end of roll.  
Mid-roll rewind also possible.  
Flash:Built-in flash with red-eye reduction lamp.  
Flash is automatically activated in low-  
light conditions.  
Data recording: Optical recording system (print  
type information only)  
Power source: One 3V lithium battery (CR2).  
Dimensions: 123 (W) x 50 (H) x 36 (D) mm (4.8  
x2x1.4in).  
Weight: 130 g (4.6 oz) (without battery).  
Design and specifications are subject to  
change without notice.  
21  
 
San-Ei Building, 22-2, Nishi Shinjuku 1 -chome, Shinjuku-ku, Tokyo, Japan. Tel. 03-3340-2211  
OLYMPUS OPTICAL CO., LTD.  
Two Corporate Center Drive, Melville, NY 11747-3157, U.S.A. Tel. 1-800 "O" CAMERA(622-6372)  
(Premises/Goods delivery) Wendenstrasse 14-18, 20097 Hamburg, Germany. Tel. 040-237730  
OLYMPUS AMERICA INC.  
OLYMPUS OPTICAL CO. (EUROPA) GMBH.  
(Letters) Postfach 10 49 08, 20034 Hamburg, Germany.  
491B River Valley Road, #13-04 Valley Point Office Tower, Singapore 248373  
Tel.7387838/1-800-OLYMPUS(6596787)  
OLYMPUS SINGAPORE PTE. LTD.  
OLYMPUS KOREA CO., LTD. 8F Central Banking Corporation Bldg., 826-20Yoksam-dong, Kangnam-gu, Seoul 135-081 Korea. Tel. 02-3466-2910  
Fax. 0081-3-3346-8380  
Tel. 00852-2730-1505 Fax. 00852-2730-7976  
This device complies with part 15 of the FCC Rules. Operation is subject  
to the conditions that this device does not cause harmful interference.  
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.  
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.  
This camera complies with EU directive 89/336/EEC for CE marking.  
Die CE-Marke zeigt an, dass diese Kamera die EG-Richtlinie 89/336EWG erfüllt.  
Cet appareil photo est conforme à la directive UE89/336/CEE pour le marquage CE.  
Esta cámara cumple con la directiva de la Unión Europea 89/336/EEC para la marca de CE.  
 
63039-400-OLY  
CS0474-  
A
0201  

Miele Range 07 257 46D User Manual
Multi Tech Systems Network Card MT2834ZPX User Manual
National Instruments Home Theater Server 321906B 01 User Manual
Nikon Digital Camera 2166 User Manual
Niles Audio Power Supply AC 8CX User Manual
N Tron Switch 508TX A User Manual
NuTone Ventilation Hood 8832SA User Manual
NuTone Ventilation Hood NTM Series User Manual
Panasonic Fax Machine KX FT33NZ User Manual
Panasonic Hair Clippers EH2203 User Manual