INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Industrial Paddle Fan
MODELS: PFC-48II & PFC-56II /SERIES
CAUTIONS
Photo shows
hardware included
with your new
ceiling fan.
WARNING: To reduce the risk of personal injury, do not bend the
blade brackets when installing the brackets, balancing the blades,
or cleaning the fan. Do not insert foreign objects in between rotating
fan blades.
WARNING: To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked “Acceptable for Fan Support” and
use mounting hardware provided with the box.
WARNING: To reduce the risk of fire, electric shock, do not use this
fan with any solid-state speed control device.
This product must be mounted and wired in compliance with all local
and national electrical codes.
OUTLET BOX
MOUNTING
BRACKET
Before wiring the ceiling fan, turn off electric power at the circuit
breaker or fuse box and leave off until installation is complete.
Mount outlet box so that it will support at least 35 pounds.
Note: the weight of the fan is as follows:
PFC-48 14 lbs. PFC-56 20 lbs.
UPPER CANOPY
SPRING BUSHING
NUT
LOCATION
DOWN ROD
COTTER PIN
BUSHING
1. When fan is installed, you must allow a minimum of 10 feet be-
tween floor and bottom of fan blades.
LOCK WASHER
2. For this model, the center of the fan must be located at least 32”
from any vertical surface - wall, doors, partitions, etc. This allows
minimum clearance for fan blades.
BOLT
SET SCREW
LOCK BOLT
LOWER
CANOPY
3. Do not mount fan below, next to or between air ducts, beams or
any other obstructions which may interfere with the natural air flow
pattern created by the fan.
BLADE
BLADE
HOLDER
GASKET
4. Place fans near constantly opening doors and shipping bays to
produce an “air shield” effect that helps keep out cold air in winter
and dust, odors and insects in the summer.
BLADE SUPPORT
BRACKET
MOTOR UNIT
5. If desired, fans can be installed directly above heat producing
machinery to reclaim the heated air.
FIGURE 1
6. For maximum air flow, fans should be located above aisles in
warehouses and storage areas.
SUPPLY
GROUND
GREEN
GREEN
WHITE
BLACK
7. Make sure fan voltage is compatible with your electrical system.
8. FOR SLOPED CEILING INSTALLATIONS ONLY: Ball and socket
mounting system will work on sloped ceilings up to 22° maximum
(rise/run = 5/12).
SUPPLY NEUTRAL
SUPPLY HOT
FIGURE 2
|