INSTALLATION INSTRUCTIONS FOR PART 99-7322
APPLICATIONS
Hyundai Azera
2006-2010
99-7322
KIT FEATURES
• DIN Radio Provision with Pocket
• ISO Radio Provision with Pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) Trim Plate
C
B
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-1004 - Hyundai/KIA harness 2004-up
• 70-7303 - Hyundai/KIA harness 2009
Antenna Adapter:
A
• 40-KI10 KIA antenna adapter 2007-up
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
99-7322 DASH DISASSEMBLY
HYUNDAI AZERA 2006-2010
A
1
2
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
Remove (1) Phillips head screw from
bottom right hand corner then unclip
and let the panel below the steering
column hang. (Figure A)
3
4
Remove (1) Phillips screw from the
lower left side of the radio panel
behind panel removed in step 2.
(Figure B)
B
Unclip and remove the trim panel
above the radio that extends across
the dash to the passenger side.
(Figure C)
C
1
99-7322 DASH DISASSEMBLY
HYUNDAI AZERA 2006-2010
D
5
6
7
8
Remove (3) Phillips screws from the
top of the radio trim panel. (Figure D)
Remove (2) Phillips screws from
under radio trim panel. (Figure E)
Unclip and remove the entire trim
panel surrounding the radio. (Figure F)
Remove (4) Phillips screws securing
the radio. Unplug and remove radio.
(Figure G)
E
Continue to kit assembly.
G
F
2
99-7322 KIT ASSEMBLY
DIN RADIO PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
1
2
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs outward. (Figure A)
Slide the aftermarket radio into the
cage and secure. (Figure B)
Continue to final assembly.
B
3
99-7322 KIT ASSEMBLY
ISO DIN RADIO PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
1
2
3
Mount the ISO Brackets to the after-
market radio using the screws sup-
plied with the radio. (Figure A)
Slide the radio into the radio opening
until the side clips snap into place.
(Figure B)
Snap the trim plate into the Radio
Housing. (Figure B)
Continue to final assembly.
B
4
99-7322 FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5
99-7322 INSTRUCTIONS
1-800-221-0932
REV. 04/27/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7322
|