C O N T E M P O R A R Y
H o i z o n t a l F a n H e a t e r
SABS
IEC60355
M o d e l :
3 5 1 0 0
1200W
PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 y e a r g u a r a n t e e
fan setting
CAUTION
-
-
-
Heating at reduced power; turn the thermostat
knob (right) to setting • (1000w)
1
Read all instructions before using the fan heater.
2
Only connect the fan heater to a single-phase socket
with main voltage as specified on the rating plate.
This appliance meets the electromagnetic
Heating at full power; turn the thermostat knob
(right) to setting •• (2000w)
3
4
Switching off; turn the switch knob (left) to setting 0.
compatibility requirements specified in EN 55104/95
with regard to interference with radio and TV sets.
Do not leave your home while the appliance is in
use. Ensure that the switch is in the OFF (0) position
and that the thermostat is in the minimum position.
Always unplug the appliance.
Regulating the thermostat:
•
When the room has reached the desired
temperature, turn the right thermostat knob in an
anti-clockwise direction up to where the appliances
switches off and not beyond.
5
6
Keep combustible material such as furniture,
cushions, bedding, paper, clothes, curtains etc. at
least 100cm away from the fan heater.
•
The temperature is “fixed” in this way and will be
automatically regulated and kept at a contant level
by the thermostat.
If wall mounted do not fix to combustible material
such as wooden, synthetic or plastic surfaces. Do
not hang anything on or in front of the fan heater.
Always unplug the heater when not in use. Do not
pull the cord to unplug the heater.
CLEANING AND MAINTENANCE
•
Before cleaning always remove the plug from the
7
8
9
electrical socket.
•
•
Clean the air intake and outlet grilles frequently.
Never use abrasive solvents or powders.
Keep the air inlet and outlet free from objects; at least
1m in front and 50cm behind the heater.
Do not install the heater below an electical socket.
WARNINGS
10 Do not let children or animal touch or play with the
fan heater. Pay attantion! The air outlet gets hot
during operation (more than 80°C).
•
Do not use the heater to dry laundry.
•
Never obstruct the intake and outlet grilles (danger of
overheating).
11 Do not cover, if covered there is a risk of overheating.
12 Do not use the fan heater in the immediate
surroundings of a bath, shower or swimming pool.
13 Do not use the fan heater in rooms with explosive
gas or while using flammable solvents, varnish or
glue.
•
•
•
The appliance must be positioned so that the
switches and other controls can not be reached by
children or persons using the bath tub or shower.
In case the power cord is damaged send it to the
nearest after sale service recommended by the
supplier for the replacement.
14 In case the power cord is damaged send it to the
nearest after sale service recommended by the
supplier for the replacement.
Do not use in rooms with less than 4m² floor area.
SAFETY DEVICE
•
The heater is fitted with a safety device which
will switch the appliance off in case of accidental
overheating. (eg: obstruction of air inlet and outlet
grilles, motor turning slowly or not at all.)
INSTALLATION
•
This appliance requires no installation and should be
used soley as a portable device.
•
To reset, disconnect the plug from the mains power
for a few minutes, remove the cause of overheating
then plug the appliance in again.
OPERATION
-
Turn the thermostat knob (right) in a clockwise
direction until it reaches the maximum setting.
Summer service (ventilation only): turn the knob to
-
Service Centre Share Call: 086 111 5006
w e b : w w w. c r e a t i v e h o u s e w a r e s . c o . z a
|