Mamp;S Systems Speaker System MNC MNCB User Manual

INTRODUCTION  
M&S Systems is introducing cube speakers (MNC) and a cube speaker  
package for Home Theater applications (MNCS) offering quality sound at an  
affordable price. The compact size allows for installation in any room without  
being intrusive to your decor. These products also offer many features,  
including the following:  
·
·
·
·
·
·
360° swivel speaker allow for full area coverage  
A complete frequency range when a subwoofer is added  
Ceiling or wall mount  
Compact design  
Shielded magnets for the cubes and center channel  
Mounting bracket and mounting screws for the cubes  
DESCRIPTION  
MNC units have dual 2-1/2”, two-way speakers with paper cones. Each  
package consists of one pair of speakers per MNC which are available in  
white (MNC) and black (MNCB) matte finishes.  
Frequency Response  
Maximum Power Rating  
Continuous Power Rating  
Impedance  
250 Hz to 15 kHz  
70 Watts  
35 Watts  
4 Ohms  
6.5 “  
Height  
Width  
3.5 “  
Depth  
4.5 “  
Weight  
2.33 lbs.  
The center channel for the Mini-Cube Home Theater Package has dual 4”  
speakers with polypropylene cones and a ½” polycarbonate dome tweeter. It  
is available in a black matte finish.  
Mini-Cube Home Theater Package  
Model MNCS / MNCSB  
Frequency Response  
Maximum Power Rating  
Continuous Power Rating  
Impedance  
Height  
Width  
250 Hz to 15 kHz  
70 Watts  
35 Watts  
6 Ohms  
5.4 “  
Mini-Cube Speakers  
Model MNC / MNCB  
14.5 “  
Depth  
5.9 “  
Weight  
8 lbs.  
Instruction Manual  
1 of 7  
 
CENTER  
LT  
RT  
AMP  
LT  
RT  
POWERED  
SUBWOOFER  
RT FRONT  
LT FRONT  
Figure 2  
AMP  
5. The MNCS system may be connected two ways depending on the  
amplifier used with the system. The major difference is the subwoofer  
connections.  
LT REAR  
RT REAR  
·
An amplifier with a subwoofer output connection, usually a RCA type  
connector would be the preferred connection when used with the MNCS  
subwoofer (see figure 3). A shielded audio cable is required for this  
setup with a Y-adaptor connecting the audio cable to left and right “LINE  
INPUT” on the subwoofer.  
Figure 4  
6. IMPORTANT! Make sure there are no loose strands of wire touching  
each other across the speaker or amplifier terminals. This can create a  
short circuit and damage your electronics.  
7. Plug your amplifier or receiver in, turn it on, and enjoy your new music  
system.  
·
CENTER  
SETTING UP THE SYSTEM  
LT FRONT  
RT FRONT  
AMP  
Use the settings on the amplifier/receiver for the MNC. If a separate  
subwoofer is being added, the volume and crossover frequency will need to  
be set (see notation under MNCS setup).  
POWERED  
SUBWOOFER  
The MNCS system will require setting up the front, center, and rear speakers  
as recommended in your amplifier/receiver instruction manual. The  
subwoofer provided with the system allows setting of the phase, volume,  
crossover frequency, and an auto power control.  
LT REAR  
RT REAR  
·
The phase switch is set for the best bass sound. Switch between the 0-  
180 position until the bass is loudest. In some applications, there may be  
no noticeable difference and in this case leave the switch in the 0  
position.  
Figure 3  
·
The other option requires the front left and right speaker cables be  
routed from the amplifier through the subwoofer to the speakers. The  
wires from the amplifier should be connected to the “HIGH LEVEL  
INPUT’ and the cables going to the speaker should be connected to the  
“HIGH LEVEL OUTPUT” on the subwoofer (see figure 4).  
·
·
The crossover frequency can be set between 40 and 180Hz. It is  
recommended that the control be set to 180Hz with the mini-cube  
speakers.  
The volume control should be set to the desired bass level for the  
system.  
4 of 7  
5 of 7  
 
·
The power switch can be set to OFF-AUTO-ON. The OFF position  
disables the subwoofer completely. The AUTO position puts the  
subwoofer in a standby mode (low power) when the system is not in use.  
When a signal is applied, the subwoofer is automatically turned on. The  
ON position is a constantly ready with or without a music signal. The  
AUTO position is recommended for most applications.  
WARRANTY  
M&S Systems Limited 2-Year No-Fault Product Warranty  
M&S Systems warrants for 2 years all products to be free of defects (M&S Systems honors  
the 10-Year No-Fault warranty for AirVac Gold power units. See section below). The  
warranty period begins from either (1) the date of “first user” purchase of this product or  
(2) the first close of escrow date on a residence in which this new product was originally  
installed. This warranty extends to the original user of the product and to each subsequent  
owner of the product during the term of this warranty. M&S Systems will repair or replace,  
at its option, parts and materials at no charge. Parts supplied under this warranty may be  
new or rebuilt at the option of M&S Systems.  
SERVICE & TROUBLESHOOTING  
M&S Systems is committed to producing high quality products for the home.  
If you have any questions or problems with the speaker systems or the  
system is not operating properly, contact your M&S installer or call M&S  
Systems at (800) 366-9422.  
If, during the limited warranty period, it appears as though this product contains a  
defect which is covered by this limited warranty, call our toll free service number  
before dismantling the product (1-800-877-6631). Remember to attain a Return  
Authorization Number (RAN) before returning any product to M&S Systems. Send  
this product freight pre-paid and insured to our service center for warranty repair.  
You will be advised on shipping instructions when you call the toll free service  
number. M&S Systems will return the repaired product freight pre-paid within the  
U.S.A. The installing dealer or distributor may assist you, at your choice and  
expense, with returning product for repair. Please include a brief description of the  
problem and a dated proof-of -purchase receipt with any product that is returned for  
warranty repair. ANY PRODUCT RETURNED WITHOUT  
A
RETURN  
AUTHORIZATION NUMBER WILL BE REFUSED.  
This limited warranty is in lieu of any other warranties, express or  
implied, including any implied warranty of merchantability or fitness for a  
particular purpose or otherwise, and of any other obligations or liability on  
the seller’s part. This limited warranty does not cover damage caused by  
improper installation, the violation of applicable building or electrical codes  
or the use of non-M&S/non-AirVac wire (excluding structured wire packages),  
cable (excluding structured wire packages) or wall housings. This limited  
warranty applies only to products installed in a private residence.  
Under no circumstances shall the seller be liable for consequential, incidental or special  
damages arising in connection with use, or inability to use this product. In no event shall  
seller’s liability, for breach of warranty, breach of contract, negligence, or strict liability,  
exceed the cost of the product covered hereby. No person is authorized to assume for us  
any other liability in connection with the sale of this product.  
Some states do not allow the exclusion or limitation of consequential, incidental or special  
damages, so the above limitation or exclusion may not apply to you. This limited warranty  
gives you specific legal rights, and you may also haveother rights which vary from state to  
state.  
115909 Rev. A  
115909  
6 of 7  
7 of 7  
 

KTM Motorcycle Accessories 250 EXC User Manual
Lennox Hearth Door 38ABF User Manual
Lennox Hearth Indoor Fireplace SYM 35N User Manual
Liebherr Beverage Dispenser EWTNes 2956 User Manual
Lifescan Blood Glucose Meter OneTouch Ultra User Manual
Linksys Switch SD2005 SD2008 User Manual
Loewe DVR Viewvision DR+DVB T User Manual
Magnadyne Remote Starter X11 User Manual
McCulloch Chainsaw 41BY46NQ077 User Manual
Metra Electronics eBook Reader 95 8224 User Manual