Modules for
24 + 2Giga N-WAY SNMP Ethernet Switch
Short Guide
English
LINDY No. 25032 2 Port RJ-45 Gigabit 10/100/1000Base-T
LINDY No. 25033 1 Port Fibre Optic Gigabit Type SC 1000Base-SX
LINDY No. 25034 2 Port Fibre Optic Gigabit Type SC 1000Base-SX
LINDY No. 25035 1 Port Fibre Optic Fast Ethernet Type SC 100Base-FX
LINDY No. 25036 2 Port Fibre Optic Fast Ethernet Type SC 100Base-FX
Please find the complete detailed user manual in PDF format on
the CD-ROM enclosed with the 24+2Giga SNMP N-Way Switch.
Unpacking
The product should contain the following items:
o One module according to the LINDY part number, check from Part No. above.
o This Short Guide
Installation
Before you install the module in the 24+2Giga SNMP Switch, turn off the power to the switch.
Unscrew the face plate of the module slot, this is on the front of the 24+2Giga SNMP Switch.
Then install the module by fixing the two module screws. Switch on the power to 24+2Giga
SNMP switch again.
After the Switch is powered on, it will perform “self-diagnostic” (POSD). This process takes
about 1 min and 40 seconds to complete, during this process, the “DIAG” LED will blink green
and the Switch will not respond to any configuration program. All the connections to the Switch
will not be available at this time. When the process is completed, the “DIAG” LED will stay solid
green.
The following table describes the meaning of each LED indicator.
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (JUNE 2003)
|